The Realme 13+ 5G RMX5000 Flash File helps you upgrade, downgrade, or reinstall Firmware Stock ROM and fix software issues like Bootloop, IMEI, or Dead Boot on your device.
In this article, we’ll guide you through everything you need to know about downloading and using the Realme 13+ 5G Flash file.
Download Realme 13+ 5G Firmware
- RMX5000export_11_14.1.0.410%28EX01%29_2024090103410000
- OPLUS Flash Tool (Oppo/Realme/Oneplus)
- USB Drivers
Realme 13+ 5G Specs
The Realme 13+ 5G is powered by the latest Mediatek Dimensity 7300 Energy chipset. It comes with 8GB of RAM and features a 5000mAh non-removable battery with 15W fast charging. Running on Realme UI 5.0 based on Android 14, the phone includes 128GB of internal storage and a dedicated SD card slot for expanding storage.
How To Flash Realme 13+ 5G Firmware File:
- Download and install the USB Drivers. (skip if already installed)
- Download the required flash file version from the above inks.
- Extract the firmware using WinRAR or 7Zip.
- Open the oplus_flash_tool.exe.
- Load the Firmware on the flash tool.
- Click the Download button.
- Turn off your phone completely.
- Press and hold both the Volume Up and Volume Down buttons, then connect the phone to your PC using a USB cable.
- Once the phone is detected in the tool, flashing will start.
- You will see a flashing bar indicating the flashing process.
- wait for the flashing process to complete. (it usually takes 5-10min)
- Once done, you see a Download success message.
- Unplug and Power on your Device. enjoy.
Note: You need authorized login credentials to access the Flash Tool to install firmware files on your device.
Important Note:
- Backup Your Data: Flashing will erase everything on your phone, so make sure to back up important files before proceeding.
- Firmware: Using the wrong firmware can brick your device. Double-check that you have the correct version for your model.
- Charge Your Phone: Ensure your device has at least 50% battery life to avoid any interruptions during flashing.
- Be Patient: The flashing process can take time. Do not disconnect your device until the process is fully completed.
Troubleshooting Tips
- If your device is not recognized by the computer, please reinstall the USB driver and change the COM Port.
- Use a good quality USB cable for better connectivity and faster data transfer.
- If flashing fails, retry the process and follow the steps carefully.
- If your device gets stuck at the boot screen, try performing a factory reset or re-flashing the device with a different flash file.
I hope by following our guide you have successfully flashed your device and restored it to working condition. If you still have any questions, you can share them in the comment section.
