Jio Bharat V2 JBV161W1

Download the official Firmware Stock ROM for Jio Bharat V2 JBV161W1 based on KaiOS. The Stock ROM is official software that comes pre-installed on your device. Flashing this firmware can fix issues like:

✅ Erase Userdata
✅ FRP Lock Remove
✅ Hang Logo/Bootloop
✅ Software Update/Downgrade
✅ Dead Boot Repair

Below, you’ll find the download links for the ROM and flash tool, along with a step-by-step guide to help you install the stock firmware on your phone.

Download Jio Bharat V2 JBV161W1 Flash File:

• JIO_JBV161W1_000_02_09_121023.zip
• SPD Flash Tool (Upgrade)
• SPD Usb Driver

How to Flash or Install Firmware on Jio Bharat V2 JBV161W1

Required:

• SPD Flash Tool
• SPD USB Drivers
• A Windows Computer
• Good Quality USB Cable
• Make Sure your Phone is charged 30%

Flashing Instructions

1. Download and install the USB Driver on your Windows PC. (Skip if already installed.)
2. Download the firmware from the above links or by searching on Google.
3. Extract the firmware file using WinRAR or 7-Zip.
4. Open SPD_Upgrade_Tool.exe to launch the tool.
5. Click the Gear icon and locate the extracted firmware file.
6. Click the Start button, then click Confirm to begin the flashing.
7. Power off your phone, Press and hold Volume Up + Down to enter Download mode.
8. Connect your phone to the PC via USB.
9. Wait for the Flashing Completed message.
10. Once done, close the flash tool, disconnect your device, and restart it.

Note: If the device does not enter EDL or BROM mode, you may need to use the test point method (short specific hardware pins on the device) to force the device to boot mode.